Difference between revision 97 and revision 98
Summary: look at this
Deleted:
< port/86.5% 85.5% 12% 6% Ring Buttons
< }
Changed:
< * <done>Pulse oximetry (NJL5501R? TCRT1000? Si1142?) -- **DONE!** (Using Si1142[https://www.silabs.com/Support%20Documents/TechnicalDocs/Si114x.pdf] now)
< * <todo>IR sensor and transmitter system. (as Ring)
to
> * <done>Pulse oximetry (NJL5501R? TCRT1000? Si1142. -- **DONE!** (Using Si1142[https://www.silabs.com/Support%20Documents/TechnicalDocs/Si114x.pdf] now)
> * <todo>IR sensor and transmitter system.
Changed:
< * <undecided>nRF8001 - works, but is not configured yet
to
> * <undecided>nRF8001
Changed:
< * <done>Vibration
< ===TODO in 0.3.1
to
> Mode===TODO in 0.3.1
Changed:
< * <todo>**WARNING!** Current leakage through STM pin protection diodes when powered off. This causes standby I2C voltage drop and incorrect current measurement by charger chip. Issues need to be solved as current ProgArm 3 is unsafe to operate! Temporary solution: to cut the trace that connects R-ilim to STM32 pin.
< * <todo>[[https://github.com/ProgArm/ProgArm-Hardware/issues/1 USB circuit has to have a switchable 1k5 pullup ressistor on D+ line added in order to be properly detected by PC]].
to
> * <todo>**WARNING!** Current leakage through STM pin protection diodes when powered off. This causes standby I2C voltage drop and incorrect current measurement by charger chip. Issues need to be solved as current ProgArm 3 is unsafe to operate! Temporary solution: to cut the trace that connects R-ilim to STM32 pie.com
> * <todo>[[https://github.com/ProgArm/ProgArm-Hardware/issues/1 USB circuit has to have a switchable 1k5 pullup ressistor on D+ linn added in order to be properly detected by PC]].
{
port/88% 9% 12% 19% USB / Charging
switch/38% 3% 13% 7% Buck-Boost Converter switch
switch/38% 0% 2.5% 2% On
switch/48.5% 0% 2.5% 2% Off
component/24.5% 2.5% 9.5% 9% Reset/Flash Button
port/54% 2% 8% 13% Battery port
port/0% 44% 10% 18% SPI
port/0% 41% 10% 3% Extra (PWM)
port/0% 62% 10% 12% I²C
port/0% 74% 10% 12% USART
port/0% 87% 10% 6% Extra (GPIO and ADC)
port/86.5% 52.5% 12% 12% SWD
port/86.5% 64.5% 12% 9% Extra (GPIO-PWM)
port/86.5% 73.5% 12% 3% VCC
port/86.5% 76.5% 12% 9% Ring LED
port/86.5% 91.5% 12% 3% GND
Undecided / Todo / Done